Kleberoboter/English: Difference between revisions
m (→Restrictions) |
No edit summary |
||
| Line 7: | Line 7: | ||
--> |
--> |
||
[[Datei:Reinraum_Sicherheit_001.jpg|250px|thumb|right|< |
[[Datei:Reinraum_Sicherheit_001.jpg|250px|thumb|right|< Gluing Robot >]] |
||
'''Device name:''' |
'''Device name:''' Gluing Robot |
||
'''Operator/Responsible for this device:''' Birgit Hübner |
'''Operator/Responsible for this device:''' Birgit Hübner |
||
| Line 23: | Line 23: | ||
== Short Description == |
== Short Description == |
||
The |
The Gluing Robot is a three-axis-table-robot (Janome JR 2400) of GLT-Pforzheim and it can be used to stick PMMA-resist foils onto wafers and insert moulds. |
||
For this you use a glue of 4 components (PMMA-solution, BPO, MEMO and DMA). |
For this you use a glue of 4 components (PMMA-solution, BPO, MEMO and DMA). |
||
| Line 36: | Line 36: | ||
The process gas is argon. |
The process gas is argon. |
||
Nitrogen is required to operate the robot. |
|||
The robot is programmed by the software JR Points version 4.6. |
The robot is programmed by the software JR Points version 4.6. |
||
| Line 58: | Line 58: | ||
The usual sizes |
The usual foil sizes are: |
||
* 75 x 30 mm² |
* 75 x 30 mm² |
||
| Line 71: | Line 71: | ||
== Restrictions == |
== Restrictions == |
||
The robot is used exclusively for the adhesive mixture |
The robot is used exclusively for the PMMA adhesive mixture. |
||
== Instructed Users == |
== Instructed Users == |
||
Revision as of 13:36, 5 February 2016
250px|thumb|right|< Gluing Robot >
Device name: Gluing Robot
Operator/Responsible for this device: Birgit Hübner
Position: building 307, room 132c
Device designation: VS 0829
Specifiaction number:
Short Description
The Gluing Robot is a three-axis-table-robot (Janome JR 2400) of GLT-Pforzheim and it can be used to stick PMMA-resist foils onto wafers and insert moulds.
For this you use a glue of 4 components (PMMA-solution, BPO, MEMO and DMA).
(work instruction: AA665)
Alternatives
Device Specifications
The process gas is argon.
Nitrogen is required to operate the robot.
The robot is programmed by the software JR Points version 4.6.
operating range: 400 x 400 x 150 mm
Established Processes
Standard successfully processes are:
gluing PMMA-foils on:
- 4", 6" - silicon wafers
- 4" - ceramics wafers
- 4" - glass wafers
The foils can have a thickness of 100 µm to 3 mm.
The usual foil sizes are:
- 75 x 30 mm²
- 63 x 23 mm²
- round foils with flat/ without flat and a diameter of 80 mm²
- the smallest possible foil which you can glue on has a size of 59 x 19 mm²
Restrictions
The robot is used exclusively for the PMMA adhesive mixture.
